Open source software for autonomous unmanned systems
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
uas:c2:spektrum_dsmx_remote_receiver [2018/05/01 22:27] kjeld |
uas:c2:spektrum_dsmx_remote_receiver [2018/05/01 22:30] kjeld |
||
---|---|---|---|
Line 31: | Line 31: | ||
The Spektrum remote receiver is put into bind mode by sending a series of pulses on the serial data pin after power-up. This is documented in the [[https://www.spektrumrc.com/ProdInfo/Files/Remote%20Receiver%20Interfacing%20Rev%20A.pdf|Spektrum remote receiver interfacing]] document. | The Spektrum remote receiver is put into bind mode by sending a series of pulses on the serial data pin after power-up. This is documented in the [[https://www.spektrumrc.com/ProdInfo/Files/Remote%20Receiver%20Interfacing%20Rev%20A.pdf|Spektrum remote receiver interfacing]] document. | ||
- | {{youtube>2JEOO2ENBLg}} | + | {{ youtube>2JEOO2ENBLg |}} |
- | //Spektrum remote (satellite) receiver bind using an Arduino Nano.// | + | |
- | This video shows how to bind the receiver as master using an Arduino Nano. Please notice that after connecting the power, the Spektrum orange LED starts flashing. After a successful binding process, the Spektrum LED turns solid orange. | + | This video above shows how to bind the receiver as master using an Arduino Nano. Please notice that after connecting the power, the Spektrum orange LED starts flashing. After a successful binding process, the Spektrum LED turns solid orange. |
The open source software used to perform this bind is available at: [[https://github.com/SDU-UAS-Center/SPM9645-Arduino-Bind]] | The open source software used to perform this bind is available at: [[https://github.com/SDU-UAS-Center/SPM9645-Arduino-Bind]] |